[DISABLE]
Disables the power link control from the CEC-compatible device to the projector.
Select this when you do not want the power status of the projector to link with the power status of the CEC-
compatible device.
[POWER ON]
Enables power-on link control.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on or starts playing, the projector turns on, starts projection, and switches
to the input that the linked CEC-compatible device is connected. While the projector is turned on, if the
CEC-compatible device starts playing, the projector switches to the input that the CEC-compatible device is
connected.
Power-off link control is disabled.
[POWER ON/OFF]
Enables power-on link control and power-off link control.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on or starts playing, the projector turns on, starts projection, and switches
to the input that the linked CEC-compatible device is connected. While the projector is turned on, if the
CEC-compatible device starts playing, the projector switches to the input that the CEC-compatible device is
connected.
When the CEC-compatible device connected to the selected input is turned off, the projector enters standby
mode.
Note
f If the CEC-compatible device does not support CEC 1.4, it may not support the link control described in the manual.
f Depending on the connected CEC-compatible device, the link control may not operate normally.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
3) When the [INITIALIZE ALL] screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
4) When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f The operations except for powering off are disabled.
Note
f When the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed after selecting [INITIALIZE ALL]
and pressing the <ENTER> button. Enter the security password set for the projector and continue your desired operation.
f The projector will enter the standby status to reect the setting values when [INITIALIZE ALL] is executed.
f Even if [INITIALIZE ALL] is performed, the settings of the following items cannot be initialized.
g [STANDBY MODE]
g [RS-232C] → [EMULATE]
g [FILTER COUNTER]
g [NETWORK]
f To initialize the settings of [NETWORK], perform the [NETWORK] menu → [INITIALIZE].
f When [INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed when the projection starts next time.
ENGLISH - 99
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
