Note
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operation instruction of the external
device regarding the output of the external device.
f The displayed signal level is assumed when the input is 30 bits.
[SCREEN SETTING]
Set the screen size.
When changing the aspect of a projected image, correct to the optimum image position for the set screen. Set as
necessary for the screen in use.
1) Press as to select [SCREEN SETTING].
2) Press the <ENTER> button.
f The [SCREEN SETTING] screen is displayed.
3) Press as to select [SCREEN FORMAT].
4) Press qw to switch the [SCREEN FORMAT] item.
f The items will switch each time you press the button.
[SCREEN FORMAT] The available items to set when [SCREEN POSITION] is selected
[16:10]
Cannot be set.
[16:9]
Three items of [CENTER], [HIGH] and [LOW] can be selected for vertical position.
[4:3]
Three items of [CENTER], [LEFT] and [RIGHT] can be selected for horizontal position.
f If [SCREEN FORMAT] is set to [16:10], the [SCREEN POSITION] cannot be set.
f When [16:9] or [4:3] is selected, proceeds to Step 5).
5) Press as to select [SCREEN POSITION].
6) Press qw to set the screen position.
[STARTUP LOGO]
Set the logo display when the power is turned on.
1) Press as to select [STARTUP LOGO].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT LOGO]
Displays the Panasonic logo.
[USER LOGO]
Displays the image registered by the user.
[OFF]
Disables the startup logo display.
Note
f When [USER LOGO] is selected, the display of the startup logo will be kept for approximately 15 seconds.
f To create/register the [USER LOGO] image, use “Logo Transfer Software”. The software can be downloaded from the Website
(https://panasonic.net/cns/projector/).
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON], the startup logo is not displayed when
projection starts before the specied time elapses after the projector enters the standby mode.
The specied time is a time set in the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].
[SHUTTER SETTING]
Enable/disable the shutter function automatically (shutter: closed/open) when the power is turned on.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
84 - ENGLISH
Chapter 4 Settings - [DISPLAY OPTION] menu
To Next Page
Loading...
