<SERIAL IN> terminal
The <SERIAL IN> terminal of the projector conforms with RS-232C so that the projector can be connected to and
controlled from a computer.
Connection
When connecting directly
When connecting with DIGITAL LINK compatible devices
D-Sub 9p (female)
D-Sub 9p (male)
Computer
Communication cable (straight)
LAN cable (straight)
D-Sub 9p (male)
Communication cable (straight)
Computer
(Not available for PT-VMZ51S and PT-VMZ41)
Projector connecting terminals
D-Sub 9p (female)DIGITAL LINKDIGITAL LINK
DIGITAL LINK compatible device
Projector connecting terminals
Note
f The destination of [RS-232C] (x page 93) must be set according to the connection method.
f When connecting by a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY
MODE] (x page 92) to [NORMAL] to control the projector in standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be controlled during standby.
Pin assignments and signal names
Outside view
Pin No. Signal name Details
(9)(6)
(5)(1)
(1)
― NC
(2)
TXD Transmitted data
(3)
RXD Received data
(4)
― NC
(5)
GND Earth
(6)
― NC
(7)
CTS
Connected internally
(8)
RTS
(9)
― NC
Communication conditions (Factory default)
Signal level
RS-232C-compliant
Sync. method
Asynchronous
Baud rate
9 600 bps
Parity
None
Character length
8 bits
Stop bit
1 bit
X parameter
None
S parameter
None
158 - ENGLISH
Chapter 7 Appendix - Technical information
To Next Page
Loading...
