3) Press as to select [PASSWORD POLICY], and press the <ENTER> button.
f The [PASSWORD POLICY] screen is displayed.
PASSWORD POLICY
RETURN
- Reusing passwords is not recommended.
- Password cannot be blank.
- A password consisting of at least eight half-width characters
and contaning characters of at least three of the
following four types is recommended.
- Uppercase letters
- Lowercase letters
- Digits
- Symbols(~!@#$%^&*()_+\|}{][<>.,/?`)
Setting the administrator account for the rst time
Set the user name and password of the administrator account.
1) Press as to select [ADMINISTRATOR ACCOUNT].
2) Press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
3) Press as to select [USER NAME], and press the <ENTER> button.
f The [USER NAME] screen is displayed.
f The factory default setting of user name is “dispadmin”.
4) Press asqw to select a character, and press the <ENTER> button.
f Up to 16 characters can be entered.
5) After entering the user name, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
6) Press as to select [PASSWORD], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
7) Press asqw to select a character, and press the <ENTER> button.
f Up to 16 characters can be entered.
f The password cannot be blank.
8) After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
9) Press as to select [PASSWORD CONFIRM], and press the <ENTER> button.
f The [PASSWORD CONFIRM] screen is displayed.
10) Enter the password entered in Step 7).
11) After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
12) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
13) Press qw to select [OK], and press the <ENTER> button.
Note
f For restrictions on character strings that can be set for password, refer to [PASSWORD POLICY] (x page 106).
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
f The user name and password of a standard user account without administrator rights can be set on the [Set up password] page
(x page 137) of the web control screen.
ENGLISH - 107
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
