Panasonic SOLID SHINE PT-VMZ51 - Air Filter Unit Installation and Counter Reset; Attaching the Air Filter Unit and Cover; Resetting the Air Filter Usage Counter

Attention
f After washing the air lter unit, dry it thoroughly before attaching it back to the projector. Attaching a wet unit will cause an electric shock or
malfunction.
f Do not disassemble the air lter unit.
Note
f Replace the air lter unit with a new optional Replacement Filter Unit (Model No.: ET-RFV500) if it is damaged or if the dirt does not come
off even after washing
Attaching the air lter unit
Tab
Air lter unit
Sponge
Fig. 1 Fig. 2
1) Attach the air filter unit to the projector. (Fig. 1)
f Hold the air lter unit with the tab on the left side as shown in the gure, attach it from the right side, and
push the tab until it clicks.
f Take care not to remove the sponge (Fig. 2) on the side of the air lter unit when attaching the air lter unit.
f Do not press on the crease part of the air lter when pressing into place.
2) Attach the air filter cover to the projector.
f Perform in the reverse order of the Step 2) of “Removing the air lter unit” (x page 146) to close the air
lter cover. Make sure to press the air lter cover rmly until it clicks into place.
f When the air lter unit is attached to the projector, proceed to the “Resetting the air lter counter” (x page 147).
Note
f When using the projector, be sure to attach the air lter unit. If it is not attached, the projector will suck in dirt and dust causing a malfunction.
Resetting the air lter counter
1) Turn on the projector.
2) Press the <MENU> button on the remote control or the control panel.
f The main menu screen is displayed.
3) Press as to select [PROJECTOR SETUP].
4) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
5) Press as to select [FILTER COUNTER].
6) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
7) Press as to select [FILTER COUNTER RESET] and press the <ENTER> button.
8) When the confirmation screen is displayed, press qw to select [OK], then press the <ENTER> button.
f The [PROJECTOR SETUP] menu → [FILTER COUNTER] → [FILTER COUNTER] is displayed as “0H”.
Note
f When the projector is used without resetting the lter counter, the actual lter usage time (counter numeric value) will not be able to be conrmed.
ENGLISH - 147
Chapter 6 Maintenance - Maintenance/replacement