- 110 -
3. Select two photos for L (left) and R (right) with / / / and
(red)
●
You can only select photos of the same recording date and the same
pixels.
●
You may not be able to view the created 3D photo properly if you
transpose the L and R photos.
4. Create the 3D photo with OK
●
If your selected photos are not suitable for the 3D photo, the error
message will be displayed and you will return to the photo selection
screen (step 3).
●
To save the 3D photo in the SD Card, press OK and follow the on-
screen instructions.
●
After the photo is saved, the photo selection screen will be displayed
(step 3). Select photos again to create another 3D photo or exit from
Multi Shot 3D mode.
■ To enjoy the saved 3D photos
Saved 3D photos are displayed in the thumbnail view. Wear the 3D Eyewear
and enjoy the 3D photos.
Using slideshow
Slideshow ends when all photos within the current thumbnail are viewed.
1. Select the file from the thumbnail of photos for the first view with
/ /
/
2. Start Slideshow with (red) and OK
●
To display / hide the operation guide
INFO
●
To pause (return to Single view)
OK
●
To return to thumbnail
RETURN
●
You can change the back ground music by setting Back Ground Music
in Slideshow Settings (see below).
To Next Page
Loading...
