- 51 -
■ Analogue TV
Set Analogue TV channel manually after Auto Tuning.
1. Select the channel position with numeric buttons
2. Select the channel with Channel Up / Down button
3. Search with /
4. Select Store with / and press OK to set
●
If a VCR is connected only with the RF cable, select channel position 0.
Update Channel List
By updating the Digital TV channel list, you can add new channels, delete
removed channels or change channel names and positions automatically.
●
The channel list is updated while keeping your settings in Favourites Edit,
Channel List, Child Lock, etc.
●
Depending on the signal condition, the update may not work properly.
New Channel Message
Selects whether to give a notification message when a new Digital TV
channel is found.
●
When a notification message appears, you can perform Update Channel
List pressing OK.
●
Sometimes, mainly during summer months at night, the TV may pick up
distant TV stations outside your broadcast due to favourable short term
ionosphere conditions. In such circumstances when you press OK, the TV
does not add any new channels. This is normal.
Signal Condition
Selects a channel and checks the signal condition.
A good Signal Strength is not an indication of suitable signal for Digital TV
reception.
●
Use the Signal Quality indicator as follows.
– Green bar: Good
– Yellow bar: Poor
– Red bar: Bad (Check the aerial)
●
Vertical lines show the maximum signal value of the selected channel.
To Next Page
Loading...
