Panasonic UF-890 - Information Codes (INFO. CODES)

119
4.3 Information Codes (INFO. CODES)
The 3-digit information codes display to show the unit’s status. These codes also print on the journal. The
following table indicates appropriate sections for troubleshooting.
Phase A: Call establishment
Phase B: Pre-message procedure
Phase C: Message transmission
Phase D: Post-message procedure
Phase E: Call release
Code Explanation Phase Section
001-003 Recording paper jam C, D 4.3.8
007-008 Recording paper jam C,D 4.3.8
010 No recording paper B,C 4.3.9
030 Document misfeeding B 4.3.10
031 Document too long C 4.3.10
400 Transmission error B 4.3.1
401 Transmission error B 4.3.2
402 Transmission error B 4.3.2
403 Polling reception error B 4.3.12
404 Transmission error B 4.3.3
405 Transmission error B 4.3.3
407 Transmission error D 4.3.3
408 Transmission error D 4.3.5
409 Transmission error D 4.3.5
411 Polling reception error B 4.3.12
414 Polling reception error B 4.3.12
415 Remote side mis-operation B 4.3.12
416 Reception error D 4.3.4
417 Reception error C 4.3.5
418 Reception error C 4.3.5
420 Reception error B 4.3.1
422 Transmission error B 4.3.2
434 Signal noise level too high B 4.3.6
459 Reception error C 4.3.7
490 Reception error C 4.3.5
494 Reception error C 4.3.7
495 Reception error C 4.3.7
630 Remote unit busy B 4.3.11
634 No busy tone detected B --
Phase A Phase B Phase C Phase D Phase E
Message
Transmission
Facsimile Communication Procedure
Facsimile Call
Phase