Panasonic UF-890 - Transmitter Chassis (301), Scanner Assembly (340), LED Array Assembly (333), Verification Stamp Assembly

27
2.6 Transmitter Chassis (301), Scanner Assembly (340),
LED Array Assembly (333), Verification Stamp Assembly
(1) Remove the Front Cover (105), Rear Cover
(108)
(Refer to 2.3) and the Control Panel Unit
(Refer to 2.5).
(2) Remove all the harnesses from the clamps.
(3) Disconnect Connector CN8 on the FCB PC
Board.
(4) 1 Screw and remove the Front Bracket 2 (136).
(5) 4 Screws (19).
(6) Remove the Transmitter Chassis (301)
Assembly.
(7) Disconnect Connector CN30 on the CCD PC
Board.
(8) 2 Screws (19).
(9) Remove the Scanner Assembly (340).
Note: When reinstalling the CCD Harness,
(1) Separate the CCD Harness (545) from the other
harnesses.
(2) Place the other harnesses into the Harness
Protector Film (556).
Cleaning the Mirror 1 (337), Mirror 2 (338)
Clean the Mirror 1 (337) and Mirror 2 (338) with a
soft cloth, soaked with isopropyl alcohol.
(2)
(2)
(4)
(5)
(5)
(5)
(6)
(7)
(8)
(9)
(1)
(2)
(1)
(2)
Mirror 1
Mirror 2