Panasonic UF-890 - Fuser Unit (431), Fuser Lamp (408), Thermistor Assembly (405), Paper Exit Sensor (610)

34
2.9 Fuser Unit (431), Fuser Lamp (408), Thermistor Assembly (405), Paper
Exit Sensor (610)
2.9.1 For units manufactured up to November 2001 production (UF-890 Only)
(1) Remove the Left Side Cover (107)
(Refer to 2.3).
(2) Disconnect the Fuser Lamp Harness
Connector.
(3) Disconnect Relay Connector.
(4) 1 Screw (19).
(5) Remove the Ground Strap (653).
(6) 3 Screws (4N).
(7) Remove the Fuser Unit (431).
(For units with original type Fuser Unit,
DZHP006136)
(8) Disconnect 1 Connector.
(9) 1 Screw (36).
(10) Remove the Fuser Lamp Harness 1 (558).
(For units with replacement type Fuser Unit,
DZHP000260)
(8) Disconnect 1 Connector.
(9) Disconnect 1 Connector.
(10) Remove the Fuser Lamp Harness 3 (558).
(2)
(3)
(4)
(5)
(6)
(6)
(7)
(8)
(10) Harness 1
(9)
Harness 2
(9)
(8)
(10) Harness 3
Harness 2