Panasonic UF-890 - Customizing Machine Settings

35
(11) 1 Screw (23).
(12) Remove the Fuser Lamp Terminal C (404).
(13) Remove the Fuser Lamp (408).
Caution:
When re-installing the Fuser Lamp, make sure that
the Fuser Lamp is inserted into the Fuser Unit as
illustrated on the left.
Do not touch the glass portion of the Fuser Lamp
with bare hands. Grease from the fingerprints will
shorten its life cycle, use isopropyl alcohol to clean
fingerprints.
(14) 1 Screw (1Q).
(15) Remove Connector.
(16) Remove the Thermistor Assembly (405).
(17) 2 Screws (23).
(18) Remove the Fuser Cover (401).
(19) Remove the Paper Exit Sensor (610).
(20) Disconnect Connector.
(11)
(12)
(13)
(15)
(16)
(14)
(17)
(18)
(20)
(19)