Panasonic UF-890 - ADF Roller (323), Pre-Feed Roller (325), Eject Roller (330), Feed Roller (328), Transmission Gear Assembly, Transmit Motor (346)

29
2.7 ADF Roller (323), Pre-Feed Roller (325), Eject Roller (330), Feed Roller
(328), Transmission Gear Assembly, Transmit Motor (346)
(1) Remove the Front Cover (105), Rear Cover
(108)
(Refer to 2.3), Control Panel Unit
(Refer to 2.5) and the Transmitter Chassis (301)
Assembly
(Refer to 2.6).
(2) 1 Screw (19).
(3) Remove the ADF Bracket (317) Assembly.
(4) Remove the ADF Roller (323).
(5) Remove the Pressure Spring Plate (324).
(6) Remove the Pre-Feed Roller (325).
Note:
Apply Molykote EM-50L Grease to the Pre-Feed
Roller (325).
(7) Remove the Ground Spring Plate A (316).
(8) Remove the document Eject Roller (330).
Note:
Apply Molykote EM-50L Grease to the Eject Roller
(330).
(9) 2 Screws (19).
(10) Remove the Feed Roller (328).
Note:
Apply Molykote EM-50L Grease to the Feed Roller
(328).
(3)
(2)
(4)
(5)
(6)
(7)
(8)
(9)
(10)(10)
(10)