Panasonic UF-890 - Page 305

305
(11) Insert the PCB Spacer into the mounting hole on
the EP PC Board.
(12) Connect the EP PC Board to the CN55 on the
FCB PC Board.
(13) Secure the EP PC Board by inserting the PCB
Spacer into the mounting hole on the FCB PC
Board.
(14) Remove 1 Screw on the FCB PC Board and con-
nect the GND Wire with the screw.
(15) Re-install the Rear Cover.
(16) Re-connect the Power Cord and the Telephone
Line Cable.
(17) Turn the Power Switch to the ON (I) position.
(11)
(12)
(14)
(13)
(17)
(16)
(16)