309
9.6.3.3 Error Message appears on the PC
9.6.3.4 Error Message appears on the Panafax facsimile unit
Problem Action
Error in writing to LPT1.
Unable to write to the Specified
device.
Verify that the device is connected to the computer correctly.
Verify that the power of the device is turned on.
Verify that the paper is properly loaded.
Error in writing to LPT1.
Printer timeout error occurred.
Verify that the power of the device is turned on.
Excessive data volume or number of pages may overflow the device's memory,
disabling data reception.
Increase the timeout setting value in properties (for transmission retry).
• Refer to the
Windows 95/98/Me [Details Tab] (See page 22)
Windows NT 4.0 [Ports Tab] (See page 34)
Windows 2000/XP [Ports Tab] (See page 49)
Printing is disabled due to an error in
the current printer settings.
Differences in settings such as paper size or printing orientation exists between the
application and the printer driver.
Specify the correct settings.
Cannot print because an error is
found in the current printer setting.
Verify and specify the paper size or orientation to coincide with the application
and the printer driver settings.
Software Operating Instructions of Panasonic Printing System Ver. 6
Error Message Solutions
• The available page memory on the Panafax facsimile unit may not be
enough. Either install an Expansion D-RAM Card or change the
resolution to 300 dpi in the Printer Driver Properties dialog box.
• The Paper Size setting on the Panafax facsimile unit may be set
incorrectly (i.e. Installed A4 size paper but the setting is for Letter size
and specify to print a A4 size document). Check if the paper size is
properly set.
• Check if the Page Size setting specified in the document is coincide with
the setting in the Printer Driver Properties dialog box.
* PRINTING PC DATA *
Insufficient Memory
* PRINTER MODE *
WRONG PAPER SIZE
To Next Page
Loading...
