Panasonic VL-V900 - Page 20

3. Connect
the AC cable to the AC IN terminal on the top of the power unit, and the DC cable to the DC OUT terminal
on the bottom of the power supply unit, and then securely fasten the screws (C).
Front view
*1
C
Top view
*1
Bottom view
*1
AC cable
binde
r hole
AC IN terminal
DC cable
binde
r hole
DC OUT terminal
*1
View with the cable covers removed.
R Recommended torque:
–
AC terminal: 0.4 N·m {4.1 kgf·cm}
– DC terminal: 0.45 N·m {4.6 kgf·cm}
CAUTION
R Insert
the AC and DC cables firmly all the way into the terminals. If the cables are not inserted all the way, heat
may be generated.
4. Use the cable binders (accessory) to secure the AC and DC cables (double-coated area) to the power supply unit.
5. Make sure to replace the cable covers (B) and then securely fasten the screws (A).
Mounting on a DIN rail
Follow the procedure in the order described below so that hook
(A) is positioned at the bottom.
1. Hang the top hooks (B) on the DIN rail (C).
2. Pull and hold the lever down (D).
3. Secure the bottom hook (A) to the DIN rail (E).
C
E
D
B
A
20
4. Installation