Panasonic WJ-NV200K - Stop Buzzer Beeping

36
37
Event action Description
Mode*
1
A B C D
Alarm action Display the alarm
icon on a web
browser
The alarm icon will be displayed on the event
error display area of the web browser.
b
×
b
×
Display the alarm
message on a
web browser
A window that notifies of an event occurrence will
be displayed on the web browser.
* The alarm message displayed last has priority.
To close the window, click the [x] button.
● × ● ×
Record the alarm
logs
Time and date of the event and event information
will be recorded in a log list.
b b b b
*2
Send a mail that
notifies of an
event occurrence
An e-mail notifying of the event and its time and
date (alarm mail) will be sent to registered e-mail
addresses (up to 4).
● × ● ×
Provide an alarm
notification to a
PC according to
the Panasonic
alarm protocol
setting
When an event occurs, a notification will be sent
to a PC in accordance with the settings made
under [Panasonic alarm protocol]. (☞ Installation
Guide)
● × ● ×
*1 b: Takes action regardless of the setting, ●: takes action in accordance with the setting, ×: takes no action
*2 Since no check is carried out when the action mode "Face matching alarm only" is set to [Off], there is no
entry made into the log either.
Stop buzzer beeping
The buzzer sounding to announce an alarm or error can be stopped from the recorder’s front panel.
Step 1
Press the [BUZZER STOP] button.
→ The buzzer will stop.
Note:
 • Thebuzzercanalsobestoppedbyresettingthe
alarm action or error action. The [BUZZER STOP]
button does not reset any of the other alarm
actions.