Register home position
The home position is set with the camera positioned at an already registered preset position.
Step 1
Register the camera preset positions on the "Camera
control [Advanced]" panel. (☞ Page 46)
Step 2
Click the [Setup] button.
→ The camera setup window will be displayed.
(☞ Page 47)
Step 3
Click the [D]/[C] button in the [Position] box to select
a preset number to register as the home position.
Select a preset number (1 - 256) to register.
Step 4
Click the [Regist] button.
→ The selected preset number will be registered as
the home position.
Step 5
Click the [Back] button.
→ The camera setup window closes, and the display
returns to the "Camera control [Advanced]" panel.
Execute auto back focus
The auto back focus function starts to automatically adjust back focus based on a subject located in the center
of the screen by clicking the execute button. For further information about this function, refer to the operating
instructions of the camera in use.
Step 1
When displaying the images on a 4-screen, select the
desired cameras.
Step 2
Display the "Camera control [Advanced]" panel (☞
page 46), and click the [Setup] button.
→ The camera setup window (☞ page 47) will be dis-
played.
Step 3
Click the [Execute] button next to "Execute auto back
focus function.".
Step 4
Click the [Back] button.
→ The camera setup window closes, and the display
returns to the "Camera control [Advanced]" panel.
To Next Page
Loading...
