5
About These Operating Instructions
There are 2 sets of operating instructions for the WJ-RT416 as follows.
• Network Operating Instructions (PDF) (this document)
• Installation Guide (book)
These "Network Operating Instructions" contain descriptions of how to configure the required settings to operate the
recorder and descriptions for how to operate the recorder using a PC via a network (operating a web browser or the
monitoring software).
Refer to the "Installation Guide" for descriptions about installation/connection, and descriptions of how to operate the
recorder using the buttons on the front panel of the recorder.
Adobe
®
Reader
®
is required to read these operating instructions (PDF) on the provided CD-ROM. When the Adobe
®
Reader is not installed on the PC, download the latest Adobe
®
Reader from the Adobe web site and install it.
The illustrations of the setup menus in these operating instructions are of the NTSC model.
System Requirements for a PC
It is recommended to install this software on a PC that meets the following system requirements. If installing on a PC
that does not meet the following system requirements, it may cause problems such as slow imaging or the software
becomes inoperable.
OS Microsoft
®
Windows
®
XP Professional SP2*
Microsoft
®
Windows
®
XP Home Edition SP2*
*: Tested and confirmed full compatibility with the English edition. Full compatibility
with other language editions cannot be guaranteed.
Computer IBM PC/AT Compatible
CPU Pentium
®
4 3.0 GHz or faster
Memory 512 MB or more
Graphic memory 256 MB or more
Display driver Overlay compatible
Monitor 1 024 x 768 pixels or more, 24-bit True color or better
Network Interface 10/100 Mbps Network interface card must be installed
Web browser Microsoft
®
Internet Explorer
®
6.0 SP2
Plug-in Microsoft
®
Windows Media
®
Player 9 Series or later
Others DirectX
®
8.0a or later
CD-ROM Drive: It is necessary to read the operating instructions and use the soft-
ware on the provided CD-ROM.
Adobe
®
Reader
®
: It is necessary to read the operating instructions on the provided
CD-ROM.
Notes:
• When the graphic memory is less than 32 MB, the monitoring software can access only four camera channels
concurrently. (When the graphic memory is less than 64 MB, the monitoring software can access only six camera
channels concurrently.)
• When the overlay control is not enabled for the display driver, the monitoring software may not start.
• The monitoring software may not start depending on the version of the display driver. In this case, upgrade the
display driver to the latest version.