150
Setting Your Machine
Fax Parameters
052 DIAGNOSTIC
PASSWORD
(----) Setting the password for Remote Diagnostic Mode. Please
ask your Panasonic Authorized Dealer for details.
053 SUB-ADDRESS
PASSWORD
(----) Setting a 20-digit password for secured sub-address
communication.
054 FAX FORWARD *1 Invalid Selecting whether the machine performs Fax Forwarding to
the specified destination.
2 Valid
056 COVER SHEET
(HOME)
*1 Off Setting the home position of the Cover Sheet parameter in
the Select Mode. (See page 86)
2 On
064 CHANGE KEYBOARD *1 QWERTY Selects the Keyboard Type when the One-Touch Sheet is
changed on the Keyboard. (It is available when the optional
Keyboard (DA-KB180) is installed.)
2 QWERTZ
3 AZERTY
077 DEPARTMENT CODE *1 Invalid Selecting whether the machine performs the Department
Code operation.
2 Valid
078 ROTATION XMT 1 Invalid Selecting whether the machine performs rotation
transmission.
*2 Valid
082 QUICK MEMORY XMT 1 Invalid Selecting whether the machine performs Quick Memory
Transmission.
Invalid : Stores all documents into memory first before
dialing the telephone number.
Valid : Starts dialing the telephone number immediately
after storing the first page.
*2 Valid
095 DUPLEX PRINT *1 Invalid Selecting whether the machine performs duplex print when
receiving the document via G3 Fax or Internet Fax.
2 Valid
097 SPECIAL TRAY
No.1 - 3
*1 None Select a Special Tray that will not be used for printing
received faxes (Tray 1 - 4). One Tray must always be
available for receiving Faxes.
(You can specify one Tray (1 - 4) for each selection No.1, 2
and/or 3.)
2 Tray 1
3 Tray 2
4 Tray 3
5 Tray 4
099 MEMORY SIZE
(Flash Memory)
- - Displays the amount of base and optional memory installed.
(Base Memory + Optional Memory)
118 FAX FUNCTION
DETECT
1 Invalid Setting the number of digits required to determine the
entered number is a Fax Telephone number.
Upon detecting the specified number of digits, the machine
will automatically switch to the FAX Mode when it is in the
Copier Mode.
2 4-Digits
3 5-Digits
*4 6-Digits
5 7-Digits
6 8-Digits
120 sFINE RESOLUTION *1 400 dpi Selecting the S-Fine default Resolution.
2 600 dpi
133 JOB BUILD *1 Off Selecting whether the machine performs Job Build when
the total number of documents exceed the maximum
capacity of the ADF, or when scanning the documents
manually one at a time. (See page
112) (The Quick Memory
Transmission feature (Fax Parameter No. 082) is not
available when the Job Build is set to "2: On". )
2 On
No. Parameter
Setting
Number
Setting Comments
To Next Page
Loading...
