Panasonic WV-SFV531 - Page 12

12
SFR531

SFN531
This product is designed to be used
indoors. This product is not operable
outdoors.
Make sure that the product does not
become wet.
Keepthiscameraawayfromwaterandmoisture.
This product has no power switch.
Whenturningoffthepower,disconnectthe
powersupplyfromthe12VDCpowersupply
orthePoEdevice.
Beforeturningoffthecamerapowerswitch,
makesurethattheSDMOUNTindicator
(green)isturnedoff.Ifyouturnoffthecamera
powerswitchwhiletheSDMOUNTindicator
(green)islitorflashing,therecordeddatamay
becorruptedordamaged.
Handle this product with care.
Donotdropthisproduct,norapplyshockor
vibrationtotheproduct.Failuretoobservethis
maycausetrouble.
SFV531
Ifastrongshockorvibrationisappliedtothe
enclosure,itmaycausedamageorallowwater
toenterthisproduct.
About the battery
Abatteryisinstalledinsidethecamera.Donot
leavethebatteryexposedinenvironmentsof
excessiveheatasaresultofsunlightorfire.
Do not touch the dome cover with your
bare hands.
Adirtydomecovercausesdeteriorationofpic-
turequality.
About the PC monitor
Whendisplayingthesameimageonthemonitor
foralongtime,themonitormaybedamaged.
Itisrecommendedtouseascreen-saver.
When an error is detected, this product
will restart automatically.
Thisproductwillbeinoperableforaround2
minutesaftertherestartjustaswhenthe
poweristurnedon.
About the automatic status detection
function
Whenthisproductmalfunctionsduetoexoge-
nousnoise,etc.for30secondsormore,the
productwillautomaticallyresetandwillreturn
tonormalstate.Whentheproductisreset,ini-
tializationwillbecarriedoutaswhenthepower
oftheproductisturnedon.Whentheproduct
repeatedlyresets,exogenousnoiselevel
aroundtheproductmaybehighandthatmay
causemalfunction.Contactyourdealerfor
instructions.
Transmission interval
Imagetransmissionintervalmaybecomeslow
dependingonthenetworkenvironment,PCper-
formance,shootingsubject,accessnumber,etc.

Periodically images on the screen appear
to be distorted
Whenthecameraisinstalledinalocation
whereitissubjecttosmallvibrations(forexam-
ple,whenitisinstalledneardevicesthat
vibrate),imagesmayappeardistortedand
stretchedlengthways.Thisphenomenonisa
characteristicofimagepickupdevicesthatuse
MOSsensorsandiscausedbytherelationship
betweentheperiodicmovementsofthecam-
eraandthetimingthattheimagesensorreads
images.Thisisnotaproblemwiththecamera.
Toreducethepossibilityofthisphenomenon
occurring,installthecamerainasecureloca-
tion.
About SD memory card
 • ToremovetheSDmemorycardfromthe
unit,pressthe[Set]buttononthe“Live”
page,selectthe[SDmemorycard]tab,
andsettheSDmemorycardoperationto
“Notuse”.Then,removetheSDmemory
card.Alternatively,holddowntheSDON/
OFFbuttonforabout2seconds.Whenthe
flashingSDMOUNTlampgoesout,you
canremovetheSDmemorycard.