23
Waterproof treatment for the cable joint sections
Adequate waterprooftreatment is required forthecableswheninstallingthe camera with cables
exposedorinstallingitundertheeaves.Thecamerabodyiswaterproof,butthecableendsarenot
waterproof.
Besuretousethesuppliedwaterprooftape(accessory)atthepointswherethecablesareconnect-
edtoapplywaterprooftreatmentinthefollowingprocedure.Failuretoobservethisoruseofatape
otherthantheprovidedwaterprooftape(suchasavinyltape)maycausewaterleakageresultingin
malfunction.
LAN cable
Alarm input/output cable, power cable, microphone/ line input cable, audio output cable
Wind the tape in a
half-overlapping manner.
IMPORTANT:
How to wind the supplied waterproof tape
• Alsowaterproofthe2Ppowercable,4Palarmcable,and
externalconnectionsinthesameway.
• Stretchthetapebyapprox.twice(seetheillustration)and
wind it around the cable. Insufficient tape stretch causes
insufficientwaterproofing.
• To preventtheLANcable hookfromcominglooseeasily,
fittheⒿLANcablecoverontothepigtailcableasillustrat-
ed,andthenslideitinthedirectionindicatedbythearrow.
The connector of the LAN cable used with this camera
mustmeetthefollowingrestrictions.
Heightwheninserted(Frombottomtohook.):Max.16mm
{5/8inches}
Connectorwidth:Max.14mm{9/16inches}
• Toinstallthisproductoutdoors,besuretowaterproofthe
cables. Waterproof grade (IEC IP66 or equivalent) is
appliedtothisproductonlywhenitisinstalledcorrectlyas
described in theseoperatinginstructionsandappropriate
waterprooftreatmentisapplied.Theinternalpartsofbase
bracketsarenotwaterproofed.
Wind the tape in a half-
overlapping manner.
2x
Ⓙ LAN cable cover
The hook engages with the
connector terminal
Stretch the tape to
about twice.