17
c Remove the dome cover, dome cover ring and
mount bracket.
When installing the camera on a wall, use the mount bracket of the camera.
IMPORTANT:
• Procure 4 screws (M4, locally procured) to secure the mount bracket to a wall according to the
material of the installation area. Do not use wood screws and nails.
For mounting a camera on a concrete wall, use an anchor bolt (for M4) or an AY plug bolt (M4)
for securing.
• Mount the mount bracket in consideration of the camera angle in accordance with the instruc-
tions.
• Required pull-out capacity of a single screw/bolt is 196 N {44.06 lbf} or more.
• If a wall board such as plaster board is too weak to support the total weight, the area shall be
sufficiently reinforced.
The mounting conditions of the camera are described as follows:
Installation
place
Appropriate mount
bracket
Recommended
screw
Number of
screw
Minimum pull-out
strength (per 1 pc.)
Wall* Mount bracket M4 4 pcs.
196 N {44.06 lbf}
Wall One-gang junction box M4 2 pcs.
196 N {44.06 lbf}
Wall Two-gang junction box M4 3 pcs.
196 N {44.06 lbf}
* The conditions for securing the mount bracket to a wall are described here.
Preparations
To Next Page
Loading...
