Panasonic WV-SW115 - Waterproof Tape

26
Waterproof treatment for the cable joint sections
Adequate waterproof treatment is required for the cables when installing the camera outdoors. The
camera body is waterproof, but the cable ends are not waterproof.
Be sure to use the supplied waterproof tape at the points where the cables are connected to apply
waterproof treatment in the following procedure. Failure to observe this or use of a tape other than
the provided waterproof tape (such as a vinyl tape) may cause water leakage resulting in malfunc-
tion.
LAN cable
Note:
How to wind the supplied waterproof tape
 • Stretchthetapeby approx.twice (see theillustration)
and wind it around the cable. Insufficient tape stretch
causes insufficient waterproofing.
 • Make suretowindthetapesothatitdoesnotpress
down on the hook of the network cable.
 • Toinstallthisproductoutdoors,besuretowaterproofthecables.
Waterproof grade (IEC IP66 or equivalent) is applied to this prod-
uct only when it is installed correctly as described in these operat-
ing instructions and appropriate waterproof treatment is applied.
The mount brackets are not waterproofed.
Wind the tape in a half-overlapping manner.
Stretch the tape to
about twice.
2x
hook