Panasonic WV-SW115 - Attaching the Dome Cover and Dome Cover Ring; Tamperproof Screw Bit

24
a Attach the dome cover and dome cover ring to the camera by using the tamperproof screw bit
(accessory) to tighten the 3 dome cover ring fixing screws (M3). (Recommended tightening
torque: 0.58 N·m {0.43 lbf·ft})
2 Remove the cover film completely.
IMPORTANT:
• When attaching the dome cover and dome cover ring the focus may be slightly disturbed. If
this occurs, remove the dome cover and dome cover ring and make the necessary adjust-
ments.
• Before attaching the dome cover and dome cover ring, make sure that the subject is present.
• Securely tighten all the fixing screws (x3) of dome cover ring. Otherwise, water exposure may
cause damage or malfunction of camera, or camera dropping may result in injury.
(Recommended tightening torque: 0.58 N·m {0.43 lbf·ft})
• Remove the cover film from the dome cover.
Attaching the dome cover and dome cover ring