31
z Attach the dome cover to the camera by using the tamperproof screw bit (accessory) to tighten
the 3 dome cover fixing screws (M3).
x Close the screw cover.
c Remove the cover film completely.
Important:
• When attaching the dome cover the focus may be slightly disturbed. If this occurs, remove the
dome cover and make the necessary adjustments.
• Before attaching the dome cover, make sure that the subject is present.
• Securely tighten all the fixing screws (x3) of dome cover. Otherwise, water exposure may cause
damage or malfunction of camera, or camera dropping may result in injury.
(Recommended tightening torque: 0.8 N·m {0.59 lbf·ft})
• Remove the cover film from the dome.
Attaching the dome cover
Dome cover
fixing screws
Screw cover
Dome cover fixing screws
n
Ceiling
n
Wall
To Next Page
Loading...
