In order to configure a VIQS area outside of preset areas, select “except the preset positions”.
[Center]
Specifies a VIQS area for the center of the screen.
[Delete]
Deletes the VIQS area. Click the [Set] button to delete the VIQS area.
[VIQS(H.264(1))]
Select “On” or “Off” to determine whether or not to activate the VIQS function for the transmitted (H.264(1))
images.
• Default: Off
[VIQS(H.264(2))]
Select “On” or “Off” to determine whether or not to activate the VIQS function for the transmitted (H.264(2))
images.
• Default: Off
Configure the VIQS area
The VIQS area is specified by following the steps below.
1. Drag the mouse on the screen to specify the area (up to 2 areas).
→ The specified area is set to area “1(White)”, and the outline is displayed.
The areas are set in the area number order from number 1. The color next to the area number show
the color of the corresponding outline.
Operating Instructions 127
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
