61
13 Troubleshooting (continue)
13.2 Troubleshooting at the initial stage
·Sometimes the problems of incapable of cutting, unstable arc and poor cutting results are caused by some other
factors instead of the Product.
·The general cutting abnormities are listed on 【13.2.1 Troubleshooting chart at the initial stage for cutting
abnormal】.
·The “cutting abnormity” on the chart goes beyond the related items, for items marked with ○ below, please
investigate and confirm the corresponding related items.
13.2.1 Troubleshooting chart at the initial stage for cutting abnormal
13.3 The treatment and countermeasures for the identified failures
·For the problems of the peripheral parts, please purchase the genuine parts from the distributor and replace.
To Next Page
Loading...
