23
22
USER MANUALSECURITY-SERVICE SYSTEM PANDORA CAMPER
EN
CONTROL THE SYSTEM FROM A PHONE
!
for The correcT operaTion of The gsm funcTions, an owner should moniTor The sTaTus/balance of The sim card
insTalled in The sysTem. if The sim card is blocked or defecTive, gsm funcTions of The sysTem will be unavailable.
Call the system’s phone number. When it answers, enter a command code
* iT is required To enTer The “secreT pin-code” afTer dialing a command
Activate/Deactivate service mode
1. Call the system number. Wait for the answer.
2. Turn on the ignition, an authorization device (a radio tag, a remote control, a paired mobile phone
with the app installed) must be in the coverage zone, enter the “Immobilizer PIN-code” (if the “Code
immobilizer” function is enabled).
3. To activate service mode, dial the 551* DTMF command — “Activate service mode”, then enter the
“Secret PIN-code” from the owner’s personal card.
4. To deactivate service mode, dial the 552* DTMF command — “Deactivate service mode”.
Voice help
The system has a voice help menu. During a voice call to the system, dial 9* and listen to the information
about system control commands.
9
9
*
*
9
9
0
0
*
*
1
1
0
0
0
0
*
*
Repeat the last message
Silent arming
0
0
0
0
*
*
0
0
1
1
*
*
Silent disarming
Help
1
1
*
*
Arming
0
0
*
*
Disarming
Events history
5
5
1
1
*
*
Tow truck mode
Request GSM account balance
3
3
3
3
3
3
*
*
Switch on add. CAN function
5
5
0
0
0
0
*
*
4
4
5
5
6
6
*
*
6
6
5
5
4
4
Request current coordinates
Switch on additional channel
Switch o additional channel
1
1
5
5
6
6
*
*
6
6
5
5
1
1
*
*
Switch on heater
Switch o heater
6
6
6
6
6
6
*
*
9
9
9
9
9
9
*
*
Activate engine blocking
Deactivate engine blocking*
9
9
9
9
8
8
*
*
8
8
8
8
8
8
*
*
Deactivate authorization devices*
Activate authorization devices
2
2
2
2
2
2
*
*
Disable HandsFree
2
2
2
2
3
3
*
*
Enable HandsFree arming
2
2
2
2
4
4
*
*
Enable HandsFree disarming
2
2
9
9
7
7
*
*
End a call
5
5
5
5
1
1
*
*
Activate service mode (see description below)*
5
5
5
5
2
2
*
*
Deactivate service mode
To end the session, hang up the phone.
Repeat the last message
To repeat any message, press * during a voice call to the system.
Arming/Disarming
1. Call the system number. Wait for the answer.
2. Dial 1* to arm, and 0* to disarm.
For silent arming dial 10* or 00
* for silent disarming
3. The system will confirm arming/disarming. To end the session, hang up the phone.
Request current coordinates
1. Call the system number. Wait for the answer.
2. Dial 500*.
3. The system will confirm: ‘Current coordinate sent via text message’ and will send text message
with coordinates and a web link to a map to your phone.
To end the session, hang up the phone.
Request GSM account balance
1. Call the system number. Wait for the answer.
2. Dial 100*.
3. The system will confirm: ‘Balance information sent via text message’ and will send text message
with account balance information to your phone.
To end the session, hang up the phone.
Tow truck mode
This mode is intended for car transportation with preservation of arming function. Tow truck mode
can be activated only when the system is armed, it will be deactivated automatically when disarming.
1. Call the system number. If the system is in PANIC mode, receive an emergency call. Wait for the answer.
2. Dial 15* , to enable the “Tow truck” mode, the system will disable motion, shock and tilt sensors. To
end the session, hung up the phone.
3. To disable this mode, disarm the system.
Activating/Deactivating engine blocking
You can block a car engine using any phone. The engine will remain blocked
until phone command ‘Unlock engine’ will be sent and the “Secret PIN-code” will be
entered. This blocking cannot be disabled using a remote control or VALET button.
To Next Page
Loading...
Need help?
General
