Pandora Camper User Manual

9
8
USER MANUALSECURITY-SERVICE SYSTEM PANDORA CAMPER
EN
Multisystem digital 2CAN | LIN interface
Integrated digital CAN and LIN interfaces allow connection to digital buses of a vehicle for reading
information (statuses) and controlling vehicles (commands). The LIN-interface can be used to control
Webasto ThermoTopEvo and Eberspacher Hydronic/Hydronic2 heaters.
!
see deTailed informaTion on loader.pandorainfo.com
icro-USB port
The system has a buil-in micro-USB port that is used for system configuration and update via the
Pandora Alarm Studio. The system can be power from the USB, so you can configure it before installation.
Temperature
The system can determine interior, engine and outside temperature. The following sources are used:
built-in temperature sensor, connector of an external temperature sensor, digital CAN-bus, values from
additional devices.
! defaulT values: inTerior TemperaTe – builT-in sensor; engine TemperaTure – exTernal sensor; ouTside TemperaTure
– can.
Synchronized clock of the baze unit
Built in clock is automatically synchronized with the built-in GPS/GLONASS receiver
! iT is required To seT correcT uTc Time zone using The mobile app or The online-service.
Owner’s personal card
! erase The proTecTive layer carefully. do noT use any sharp
objecTs To avoid damaging of hidden informaTion under The
proTecTive layer. The informaTion is inTended only for The owner.
T
he card and The hidden informaTion cannoT be resTored.
The owner’s personal card contains private information
under a protective layer:
• PIN (the «Secret PIN-code”) is a 4-digit number. This
code can be used to disarm the system and to deactivate
immobilizer functions. It can be also used to enter programming mode. This information cannot be
changed or restored
• LOGIN – is a 10-digit number. This information is used to add the system to the online service and
mobile applications. This information cannot be changed or restored
• PASS – contains 8 characters and can consist of digits, lower and upper case letters. This information
is used to add the module to the online service and mobile applications. This information cannot be
changed or restored.
• Phone number is a phone number of the SIM-card supplied with the system. This number is not used
if you change the SIM-card.
External VALET button
An external VALET button with a three-color status
LED indicator is placed inside a vehicle (see the system
modules layout). The button is used for programing
the system, arming/disarming, activating/deactivating
dimmobilizer mode.
!
original vehicle conTrols (buTTons/levers/pedals) can be used
as The valeT buTTon. see The deTailed informaTion on loader.pandorainfo.com.
LED INDICATOR
VALET BUTTON
2-2-2-2
PIN

Pandora Camper Specifications

General

Brand	Pandora
Model	Camper
Category	Security System
Language	English