PANDORA LIGHT PRO SERVICESECURITY SYSTEM
WARNING! All control commands are transmitted via radio channel,
for maximum eectiveness and range it is recommended not to shield
aerial area (see picture) with ngers when using a remote control
7. Personal owner’s card 1
8. Engine temperature sensor 1
9. Main cable 1
10. LIN interface cable 1
11. IMMO interface cable 1
12. Relay 1
13. Fastening kit 1
14. Micro-USB cable 1
15. Packaging 1
Manufacturer reserves the right to change set and construction of the product to improve
its technological and operational parameters without notification.
REMOTE CONTROLS
Two-way remote is the main mean of control over the system.
For easily distinguishable notifications the remote uses 16 ringtones. Each ringtone
matches particular event. Remote has flashing LED indicators for additional
information.
The remote is fully operational when shipped. To switch the remote on, press and
hold button. «REMOTE ON» ringtone will play. Pressing and holding this button
again for 3 seconds will cause the remote to switch off.
R E M O T E C O N T R O L