PANDORA LIGHT PRO SERVICESECURITY SYSTEM
R E M O T E C O N T R O L
programmed neutral procedure was followed when the car was arming.
Remote and automatic engine start on automatic transmission cars will only
occur, if transmission selector lever was left in a «P» position.
When using remote and automatic engine start functions, make sure that the
car is secured with handbrake or some other means of fixating the car on a parking
position.
While system is in remote and automatic start mode, it keeps performing
all security functions of all of the security zones excluding shock sensor. To
compensate, motion sensor sensitivity and responsiveness will be increased.
If any security zone will be triggered, the engine will be immediately stopped
and alarm mode will be entered. Herewith all engine blocking functions will be
activated.
PROGRAMMED NEUTRAL PROCEDURE
(for cars with manual transmission)
If you are planning to use remote and automatic engine start on a car with manual
transmission, before arming you will need to perform following actions:
1. While ignition is being switched on and engine is running, fixate the car with the
handbrake and put gear lever to the neutral position. Programmed neutral procedure
will be switched on automatically (it depends on the system settings), press and hold
button for 3 seconds to forced switch on this program.
2. Turn the key in the ignition lock to the OFF position (the engine should still be
running) and take it out of the lock.
3. Leave the car, close the doors.
4. Press button to arm the car and lock the doors. The engine operation icon
will be spinning on LCD remote and security mode status icon will light.
5. The engine will be stopped. Now the system is ready to perform remote and
automatic engine start.
To Next Page
Loading...
Need help?
General
