USER MANUAL
PREPARING TO PROGRAM THE SYSTEM USING A COMPUTER
The system allows programming all settings and updating software of the base unit
via micro-USB cable. If the base unit has not been installed in the vehicle yet, it will be
powered via micro-USB cable while programming. To program using a computer, you
need a standard USB cable, a computer with Windows XP/Vista/7/8/10 and Pandora
AlarmStudio application.
It is required to create an account in AlarmStudio to use Pandora CLONE for remote
engine start (you can register without a connection to a system). Pandora CLONE
procedure requires Internet connection.
In preparation to the programming these stages should be followed:
• connectthesystemandPCviaUSBcable;
• startPandoraAlarmStudio;
• enter the programming settings mode by entering the «service PIN-code».
UPDATING FIRMWARE
It is recommended to update firmware of the base unit before installing and
programming the system (actual version of the firmware you can download from
tssgroup.sk). You can update firmware using AlarmStudio application after entering
programming mode or using quick boot algorithm (PIN-code is not required).
Quickbootmode:openAlarmStudio;de-energizeanddisconnectthesystem;
press and hold VALETbuttonlocatedonthebaseunit;releasethebutton
immediatelyafterconnectingthesystemandacomputerviaUSBcable;thesystem
will enter boot mode.
If the boot mode has been interrupted for some reason and the status indicator
lights red, you need to load firmware using quick boot mode (without entering the
PIN-code).
P R O G R A M M I N G T H E S Y S T E M