USER MANUAL
R E M O T E C O N T R O L
Handbrake/ neutral
indicator, Brake
pedal security zone
Low voltage
security zone
P
ARMING PROCEDURE
Arming the system allows monitoring of all security zones, locks the doors and blocks
the engine.
To arm the system when the engine is stopped, shortly press button on the
remote control. The siren will emit one sound signal and turn signals will flash once.
The remote control will play «ARMING» ringtone and security mode status icon (the
lock) will change to
~~
short press doors locking
system arming
1 ash
1 ash
1x
press
and hold
for 1 sec.
* Separate display indication of doors, original alarm status, fuel level depend on information
in CAN-bus digital protocol of specific car
For arming without sound confirmation press for more than 1 second.
Engine operation
icon
Engine is stopped
STOP
To Next Page
Loading...
Need help?
General
