USER MANUAL
PROGRAMMING THE SYSTEM
ENTERING PROGRAMMING MENU
To change the system settings or program the system using a computer or VALET
button, the system should be in programming mode. Enter programming mode
by entering the «Service PIN-code» (factory preset is 1-1-1-1). PIN-code should be
entered using external or located on the base unit VALET button. The input is
indicated by flashes of external or located on the base unit LED indicator. You can
enter the code only if the base unit is powered form USB socket or from external
power supply, the ignition is switched off, the system is disarmed and maintenance
mode is switched off.
If there is no «Service PIN-code», you can enter programming mode using the
«Secret PIN-code» written on the owner’s card.
Entering PIN-code:
• Enter the first digit of the code using VALET button. Press the button a number of
times, equals to the first digit. Pauses between presses should not exceed 1 second.
Each pressing will be confirmed with an orange LED indicator flash. A Pause for
more than 1 second and a red LED indicator flash confirm the input of the first
digit. Then you can enter the next digit.
• Enter the second digit of the code using VALET button. Press the button a
number of times, equals to the second digit. Pauses between presses should not
exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. A Pause for more than 1 second and a red LED indicator flash confirm the
input of the second digit. Then you can enter the next digit.
• Enter the third digit of the code using VALET button. Press the button a number
P R O G R A M M I N G T H E S Y S T E M
To Next Page
Loading...
Need help?
General
