PANDORA LIGHT PRO SERVICESECURITY SYSTEM
of times, equals to the third digit. Pauses between presses should not exceed 1
second. Each pressing will be confirmed with an orange LED indicator flash. A
Pause for more than 1 second and a red LED indicator flash confirm the input of
the third digit. Then you can enter the next digit.
• Enter the fourth digit of the code using VALET button. Press the button a number
of times, equals to the fourth digit. Pauses between presses should not exceed
1 second. Each pressing will be confirmed with an orange LED indicator flash.
The system will confirm correct PIN-code with the series of red and green flashes
and the system will enter programming mode. If the input was incorrect, it will be
indicated with a red LED indicator flash and the system will stay in a previous state.
New input can be attempted after 5 seconds.
Exit programming mode:
To exit programming mode turn on the ignition or turn off power of the base unit.
The system will reboot programmatically (all changes will be saved) after exiting
programming mode using ignition. All ways to exit the programming menu are
accompanied by sound signals of the siren and light signals of the LED indicator.
Light signals indicate the number of recorded devices: first green flashes indicate the
number of recorded radio tags, red flash indicates registered mobile device.
• the first orange flashes indicate the number of recorded remote controls,
• the next green flashes indicate the number of recorded radio tags,
• the last red flash indicates registered mobile device.
Status indicator lights during PIN-code entering:
Short orange ash Conrmation of VALET button pressing
Short red ash Conrmation of entering a PIN-code digit
Red and green ashes PIN-code is correct
Long red ash PIN-code is incorrect
P R O G R A M M I N G T H E S Y S T E M
To Next Page
Loading...
Need help?
General
