PANDORA LIGHT PRO SERVICESECURITY SYSTEM
will be confirmed with orange LED indicator flash. Pause for more than 1 second
and red LED indicator flash confirm the input of the first digit. Then you can enter
the next digit.
2. Enter the second digit of the code using VALET button. Press the button a number
of times, equals to the second digit. Pauses between presses should not exceed 1
second. Each pressing will be confirmed with orange LED indicator flash. Pause for
more than 1 second and red LED indicator flash confirm the input of the second
digit. Then you can enter the next digit.
3. Enter the third digit of the code using VALET button. Press the button a number
of times, equals to the third digit. Pauses between presses should not exceed 1
second. Each pressing will be confirmed with orange LED indicator flash. Pause for
more than 1 second and red LED indicator flash confirm the input of the third digit.
Then you can enter the next digit
4. Enter the fourth digit of the code using VALET button. Press the button a number
of times, equals to the fourth digit. Pauses between presses should not exceed
1 second. Each pressing will be confirmed with orange LED indicator flash. After
correct enter of the fourth digit the system will enter programming mode. The
correct input will be confirmed with the series of green and red flashes of the
LED indicator. If the input was incorrect, it will be indicated with a long red flash
of the LED indicator and the system will stay in previous state. New input can be
attempted after 5 seconds.
After correct input of PIN-code the system will enter programming mode if it was
disarmed and the ignition was switched off.
For emergency arming when the engine is stopped, press and hold VALET button for
3 seconds. The system will be armed in 30 seconds.
R E M O T E C O N T R O L
To Next Page
Loading...
Need help?
General
