Pandora Light Pro

USER MANUAL
Х5 socket (Relay module)
• Wire «1» (Blue) (CH7) — Factory setting is «Blocking N.O.» This output is used
to control blocking relay with a normally open logic (it becomes grounded
when switching on the ignition and security system is not armed). A negative
output of additional channel with maximum load current 200mA. This output is
multipurpose, it can operate in accordance with selected logic.
• Wire «2» (Orange) (CH6) — Factory setting is «ACC». The channel is used to
control accessories. If «Car with START/STOP button» setting is enabled, the channel
will control brake pedal during remote or automatic engine start. A negative
output of additional channel with maximum load current 200mA. This output is
multipurpose, it can operate in accordance with selected logic.
• Wire «3» (Brown) (CH9) — Factory setting is «Ignition». This output is used to
switch on ignition. It allows implementing automatic engine start, turbo timer,
ignition support. If «Car with START/STOP button» setting is enabled, the channel
will operate in impulse mode to control the button. A negative output of additional
channel with maximum load current 200mA. This output is multipurpose, it can
operate in accordance with selected logic.
• Wire «4» (Green) (CH8) — Factory setting is «Bypass». Output activates during
remote or automatic engine start. A negative output of additional channel with
maximum load current 200mA. This output is multipurpose, it can operate in
accordance with selected logic
• Wire «5» (Yellow) (CH10) — Factory setting is «Starter». This output is used to
switch on starter of the car. A negative output of additional channel with maximum
load capacity 200mA. This output is multipurpose, it can operate in accordance
with selected logic.
It is not recommended to assign «Starter» to any other channel.
• Wire «6» (Red) — relay module power supply 12V
W I R I N G  D E S C R I P T I O N  •  W I R I N G  D I A G R A M