1918
USER MANUAL
PANDORA MINI V3 CAR SERVICE-SECURITY SYSTEM
Mobile application
Open the mobile application. When the system is active, press and hold the
button
on the control panel until the scale is fully loaded.
Radio tag
A radio tag must be in the Bluetooth coverage area. Shortly press the control
button on the tag.
HandsFree mode
Move toward the vehicle with a remote tag (or a paired mobile phone)
.
Note! AddItIoNAl settINGs ARe RequIRed foR usING the hANdsfRee mode WIth
A mobIle phoNe.
VALET button
Enter the ”Secret PIN-code” (see the ”Emergency disarming using the VALET
button” section).
SERVICE (VALET) MODE
It is recommended to put the system into the service mode before handing
it to a car service or valet parking. When this mode is switched on, security
system stops interfering with built-in electronics and disables all functions to
ease maintenance or parking.
To enable this mode, switch on the ignition, a radio tag must be in the cov-
erage zone, enter the “Immobilizer PIN-code” (if the “Code immobilizer” func-
tion is implemented) and use one of the methods described below: Switch on/
off the service mode using a phone and the Pandora BT application
• To switch on the service mode, open the mobile application. When the sys-
tem is active, press and hold the button
on the control panel until the
scale is fully loaded.
• To switch off the service mode, open the mobile application. When the sys-
tem is active, press and hold the button
on the control panel until the
scale is fully loaded.
Note! IN oRdeR to chANGe buttoNs locAtIoN oR to Add A NeW buttoN oN the
coNtRol pANel, pRoceed to the “settINGs” -> “ActIoN buttoNs”.
Switch on/off the service mode using a radio tag
• To switch on the service mode, press and hold the button on a radio tag for
3 seconds. Release the button after 3 flashes of the LED of the radio.
• To switch off the service mode, press and hold the button on a radio tag for 3
seconds. Release the button after 3 flashes of the LED of the radio tag
.
• Switch on/off the service mode using an immobilizer button
• To switch on the service mode, enter the “Immobilizer PIN-code” and press
the immobilizer button 10 times within 20 seconds.
• To switch off the service mode, turn on the ignition and enter the “Immo-
bilizer PIN-code”.
Service mode indication
The system will confirm switching on the service mode with:
icon in
the mobile application, with a long sound signal of a Beeper and the green LED
indicator when the ignition is turned on.
The system will confirm switching off the service mode with: disappearing
the
icon in the mobile application, two long sound signals of a Beeper
and fading the green LED indicator when the ignition is turned on.