2120
USER MANUAL
PANDORA MINI V3 CAR SERVICE-SECURITY SYSTEM
• ENTER THE SECOND DIGIT • Press the VA-
LET button the number of times, equals to
the second digit. Pauses between presses
should not exceed 1 second. Each pressing
will be confirmed with an orange LED indi-
cator flash. A pause for more than 1 second
and, red LED indicator flash and a short
sound signal of the beeper confirms the in-
put of the second digit. Then you can enter
the next digit.
• ENTER THE THIRD DIGIT • Press the VALET
button the number of times, equals to the
first digit. Pauses between presses should
not exceed 1 second. Each pressing will be
confirmed with an orange LED indicator
flash. A pause for more than 1 second and,
red LED indicator flash and a short sound sig-
nal of the beeper confirms the input of the
first digit. Then you can enter the next digit.
• ENTER THE FOURTH DIGIT • Enter the
fourth digit of the code using VALET button.
Press the button the number of times, equals to the fourth digit. Pauses be-
tween presses should not exceed 1 second. Each pressing will be confirmed
with an orange LED indicator flash. After entering the fourth digit:
• If the PIN-code is correct, the system will be disarmed. It will be confirmed
with the series of red and green flashes of the LED sound signals of the
Beeper, two signals of the siren and two flashes of the light signalization
• If the PIN-cod is incorrect the system will stay in the previous state. New
input can be attempted after 5 seconds. Incorrect PIN-code is indicated with
a long red flash of the LED.
• If the system was disarmed and the ignition was off, it will enter the pro-
gramming mode after correct entering the “Secret PIN-code”. Turn on the
ignition to exit the programming mode.
LED
VALET
Automatic exit from the service mode
The system can automatically exit the service mode when a vehicle start
moving and when an authorization device is in the coverage zone (radio tag,
remote control, mobile device).
Note! No AddItIoNAl settINGs ARe RequIRed foR thIs fuNctIoN. check If the
“speed” fuNctIoN Is suppoRted foR youR cAR heRe – loAdeR.pANdoRAINfo.com.
CONTROL OVER THE SYSTEM IN CASE OF EMERGENCY
Emergency disarming using the VALET button
In case you cannot disarm the system using a phone or immobilizer tag, the
‘Secret PIN-code’ can be used. The ‘Secret PIN-code’ is written on the owner’s
plastic card under the protective layer. The code must be entered only when
the base unit is powered and the ignition is off. The PIN-code can be entered
using an external or located on the base unit VALET button. The digits input is
indicated by an external or located on the base unit LED indicator.
WARNING! mAke suRe thAt the pRotectIve lAyeR oN the oWNeR’s plAstIc
cARd Is INtAct AfteR AN INstAllAtIoN of the system. the plAstIc cARd holds
the “secRet pIN-code”
WARNING! cARefully Remove the pRotectIve lAyeR, do Not use shARp
objects to AvoId dAmAGING of hIddeN INfoRmAtIoN uNdeR the pRotectIve
lAyeR.
Entering the PIN-code:
• ENTER THE FIRST DIGIT • Press the VALET button the number of times, equals
to the first digit. Pauses between presses should not exceed 1 second. Each
pressing will be confirmed with an orange LED indicator flash. A pause for
more than 1 second and, red LED indicator flash and a short sound signal of the
beeper confirms the input of the first digit. Then you can enter the next digit.
To Next Page
Loading...
Need help?
General
