2322
USER MANUAL
PANDORA MINI V3 CAR SERVICE-SECURITY SYSTEM
Emergency control of the anti-theft functions
This section describes how to deactivate and activate anti-theft functions
(Immobilizer and Anti-Hi-jack), which use a radio tag, a remote control or
a mobile phone as an owner authorization device, and “Code immobilizer”
function, which uses standard car controls (buttons, levers, pedals) to enter the
Immobilizer PIN-code.
Emergency deactivation of anti-theft function
To temporarily deactivate the Immobilizer or Code immobilizer function
(pin-to-drive), turn on the ignition when the system is disarmed. Enter the
“Secret code” from the owner’s personal card using the VALET button. The
immobilizer functions will be being deactivated by the time the ignition is
turned off.
Emergency activation/deactivation Immobilizer/Code Immobilizer functions
Emergency control of the anti-theft functions is possible only when the
system is disarmed, the ignition is off, service mode is deactivated, a vehicle
battery is charged.
Enter the “Secret PIN-code” or the “Service PIN-code” (default value is 1-1-1-
1) to put the system in programming mode.
Pauses between presses should not
exceed 1 second. Each pressing will be confirmed with an orange LED indicator
flash. The system will confirm entering the 13th level with the red flashes of the
LED and short signals of the Siren/Beeper.
• TO DEACTIVATE THE FUNCTION – The LED indicator will be green after
entering the programming level. The system will wait 10 seconds for entering
the ‘Secret PIN-code’. If the PIN-code is not entered within 10 seconds or the
input is incorrect, the siren will sound one signal, the LED will produce the
series of red and green flashes and the system will return to the programming
menu. Enter the ‘Secret PIN-code’ that is written on the owner’s plastic card. The
system will confirm deactivating with two sound signals of the siren, a long red
LED flash and two sound signals of the siren. Turn on the ignition and then turn
off to exit programming mode. The function will be deactivated.
• TO ACTIVATE THE FUNCTION - The LED indicator will light red and the Beeper
will sound a long beep after entering the programming level. The system will
wait for action. Press the VALET button once activate the immobilizer function.
The system will confirm enabling with one short sound signal of the Siren/
Beeper and a green LED light. Turn on the ignition and then turn off to exit
programming mode. The function will be activated.
To manage Immobilizer and Anti-
Hi-Jack functions - After entering
programming mode, press the VALET
button 13 times.
To manage Immobilizer and Anti-
Hi-Jack functions - After entering
programming mode, press the VALET
button 15 times.
To Next Page
Loading...
Need help?
General
