Panduit PanTher LS8EQ - Creating Lines

CREATING LINES
26
Lines
Lines allows custom placement of vertical and horizontal lines on a label. Lines
are especially useful for creating patch panel, faceplate, or terminal block labels.
There are seven unique line settings available: Center Horizontal, Center
Vertical, Top, Bottom, Left, Right, and @ Pages. Each of these settings may
be turned on or off independently.
NOTE: The top, bottom, left, and right sides of the label will rotate with
the legend when a label is rotated.
1. The Center Horizontal setting places a line through the center of the label in
the horizontal direction.
2. The Center Vertical setting places a line through the center of the label in
the vertical direction.
3. The Top setting places a line at the top of the label.
4. The Bottom setting places a line at the bottom of the label.
5. The Left setting places a line at the far left side of the label.
A01
A02
A01 A02
A01
A01
A01