92
10.3 Move the printer
10.3.1. Move the printer to another location
：To avoid the risk of electrical shock, do not place or use this product near water or wet
locations.
：If the printer weighs more than 18 kg, then it requires two or more trained personnel to lift it
safely.
：To avoid the risk of fire or electrical shock, use only the power cord provided with this
product or the manufacturer’s authorized replacement.
：When moving the printer, follow these guidelines to avoid personal injury or printer
damage:
• Make sure that all covers and trays are closed.
• Turn off the printer, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer.
• If the printer has casters on its base, then carefully move it to the new location. Use caution
when passing over thresholds and breaks in flooring.
• Always use the handholds on the printer to lift it.
• Any cart used to move the printer must have a surface able to support the full footprint of the
printer.
• Keep the printer upright.
• Avoid violent vibrations when moving.
• Make sure that your fingers are not under the printer when you set it down.
• Make sure that there is adequate clearance around the printer.
• Damage to the printer caused by improper handling is not covered by the printer
warranty.
10.3.2. Transporting the printer
When transporting the printer, use the original packaging.
To Next Page
Loading...
Need help?
General