EasyManuals Logo

Pantum CP1100 Series User Manual

Pantum CP1100 Series
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
55
6.2.1.2. IPv6 setup
1. Turn on printer power to connect printer to network.
2. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
3. Click “Settings” – “Network settings” – “Protocol Settings” – “IPv6”.
4. Tick “Enable IPv6 protocol” and “Enable DHCPv6” (ticked by default) and then click “Apply”.
You can refresh the browser and view the “IPv6 Local Link Address” and “Stateful Address” in
“Wired IP Configuration” interface.
Note
The printer supports using the following IPv6 addresses for network printing and
management.
• IPv6 local-link address: local IPv6 address set up by oneself (addresses beginning
with FE80).
• Stateful address: IPv6 address set up by DHCPv6 server (if there is no DHCPv6
server in network, the “Stateful Address” cannot be assigned).
• Stateless address: IPv6 address set up by network router automatically (please refer
to Chapter 9.4 and print “Network setup page” view IPv6 address).
6.2.2. Wireless setup
You can set up the wireless network, wireless IP setup, Wi-Fi Direct and WPS via wireless setup
page. Before setup, please log in the embedded Web server (please refer to Chapter 6.1 for
login method).
6.2.2.1. Wireless network
1. Click “Settings” – “Network settings” – Wireless setup” – Wireless Network”.
1) If you need to set up wireless network, please click the SSID of access point (wireless
router) in search list, input secret key and click “Apply”.
6.2.2.2. Wireless IP setup
Only when the wireless network of printer is turned on, the Wireless IP Configuration can be
displayed on Web server.
1. Click “Settings” – “Network settings” – Wireless setup” – Wireless IP Configuration”.
1) DHCPv4 is ticked by default. If IP address needs to be set up manually, please cancel the
DHCPv4 checkbox ticked and input the “IPv4 Address”, “Subnet Mask” and “Gateway Address”
that you need to set up and then click “Apply”.
6.2.2.3. WPS setup
1. Click “Settings” – “Network settings” – Wireless setup” – WPS”.
1) Select the “WPS Startup Method” you need, and then click “Apply” and operate according to
page prompt.
6.2.2.4. Wi-Fi Direct setup
1. Click “Settings” – “Network settings” – Wireless setup” – Wi-Fi Direct”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pantum CP1100 Series and is the answer not in the manual?

Pantum CP1100 Series Specifications

General IconGeneral
BrandPantum
ModelCP1100 Series
CategoryPrinter
LanguageEnglish

Related product manuals