Pantum CP1100 Series - Page 120

105
Uneven print
density
• Toner cartridge is not installed
properly.
• Pull out the toner cartridge tray, remove
the toner cartridge, then insert the toner
cartridge, and insert the toner cartridge tray.
• Perform the “Fully Calibrated” setting,
please refer to Section 9.2.2 for the setting
mode.
Horizontal dark
lines
• The paper used has been
stored in the air for a prolonged
time.
• Toner cartridge is not installed
properly.
• Keep the paper in its original wrapper
before use.
• Pull out the toner cartridge tray, remove
the toner cartridge, then insert the toner
cartridge, and insert the toner cartridge tray.
Vertical dark lines
• The paper used has been
stored in the air for a prolonged
time.
• Toner cartridge is not installed
properly.
• Keep the paper in its original wrapper
before use.
• Pull out the toner cartridge tray, remove
the toner cartridge, then insert the toner
cartridge, and insert the toner cartridge tray.
Horizontal white
lines
• Toner cartridge is not installed
properly.
• Pull out the toner cartridge tray, remove
the toner cartridge, then insert the toner
cartridge, and insert the toner cartridge tray.
Vertical white lines
• The print media does not meet
the usage specification. For
example, the print media is
textured, damp, or too rough.
• Toner cartridge is not installed
properly.
• For proper use of media within the
specification range, please refer to Section
2 .
• Pull out the toner cartridge tray, remove
the toner cartridge, then insert the toner
cartridge, and insert the toner cartridge tray.