V
CAUTION - ROTATING FAN BLADES: To avoid the risk of laceration from moving fan
blades, turn off the printer and unplug the power cord from the electrical outlet before accessing
areas marked with this symbol.
CAUTION - POTENTIAL INJURY: This product uses lasers. Use of controls or adjustments
or performance of procedures other than those specified in the User’s Guide may result in
hazardous radiation exposure.
This product is designed, tested, and approved to meet strict global safety standards with the
use of specific manufacturer’s components.The safety features of some parts may not always be
obvious.The manufacturer is not responsible for any adverse consequences caused by using
parts of other manufacturers. For services or repairs other than those described in the user
document, please contact the Customer Service Center.
This product uses a printing process that heats the print media, and the heat may cause the
media to release emissions.Please read and understand the section in your operating
instructions that discusses the guidelines for selecting print media properly to avoid the
possibility of harmful emissions.
This product may produce a small amount of ozone during normal operation, and may be
equipped with a filter designed to limit ozone concentrations to levels well below the
recommended exposure limits.To avoid high ozone concentration levels during extensive usage,
install this product in a well-ventilated area and replace the ozone and exhaust filters if instructed
to do so in the product maintenance instructions.If there are no references to filters in the product
maintenance instructions, then it is not required to replace the filter for this product.
Please keep these safety instructions.
To Next Page
Loading...
Need help?
General