III
Safety Warning
Please note the following safety warnings before using the printer:
There is high-voltage electrode inside the printer.
Before cleaning the printer, make sure the power is
turned off!
Plugging and unplugging the power cord plug with a
wet hand can result in an electric shock.
The fuser unit is hot when and after printing.
Touching the fuser unit (the shaded area as shown)
may cause burns!
The fuser unit is attached with a high temperature
warning label. Please do not remove or damage this
label.
Such symbol represents it is an electrostatic
sensitive component. Do not touch any area close
to the symbols before touching the metal surface in
an area away from the symbols.
To Next Page
Loading...
Need help?
General
