Digiplex LED Keypads 9
3.2.2 Decimal Programming
Section [006] is programmed using “Decimal Programming”. In this
method, any digit from 000 to 255 can be entered.
3.2.3 Level Programming
Section [009] is programmed using “Level Programming”. In this
section only one option can be enabled. To enable the option use
the and buttons until the option you want is illuminated
then press the [ENTER] button to set the option.
3.2.4 WinLoad Programming
With the WinLoad Security System Management Software, the
Digiplex control panels and keypads can be programmed
remotely through a modem at 300 baud or on-site at 19,200
baud with a 306 Adapter. For more information refer to the
WinLoad On-Line Help.
3.3 MODULE BROADCAST
The Digiplex Control Panel’s Module Broadcast feature can be
used to copy the contents of one LED Keypad model to one or
many other LED Keypads of the same model. For example, the
programming of a 20-zone LED Keypad can be copied to many
other 20-Zone LED Keypads.
Step 1: From Normal Mode press and hold the [0] button.
Step 2: Enter [INSTALLER CODE].
Step 3: Enter section [954].
To Next Page
Loading...
Need help?
General
