4 User’s Manual
2.0 Access Codes
2.1 Programming User Codes
In addition to the master code, the Esprit control panel
can be programmed to accept up to 48 user codes.
Note: Avoid programming simple or
obvious access codes, such as your
telephone number, address or codes such
as 1234.
To create or modify access codes, follow the steps
indicated in section 2.2. The Master Code and user
codes are identified by a 2 digit user number.
2.2 Creating User Codes
1. Press [ENTER] and then enter your Master Code
(default 474747) or User Code 1. You will hear a
confirmation beep and the [
ENTER] key will flash.
2. Enter the two digit user number (01-48) for the
user code you wish to program (or 00 to change
the master code). You will hear a confirmation
beep and the [
ENTER] key will stay on.
3. Key in 4 or 6-digit user access code and press
[
ENTER]. The confirmation beep will sound again.
The [
ENTER] key will flash. You may continue
programming other user codes, or press [
CLEAR]
to exit programming mode.
Note: [2
ND] key flashes if location is empty
(no code programmed).
K6X6-EU12.fm Page 4 Tuesday, June 27, 2006 11:05 AM
To Next Page
Loading...
Need help?
General
