MW Pre-Alarm in Operation Mode
MW Anti-Mask Pre-Alarm in Test and Operation Mode
NVX80 Installation Manual 23
4.3.2 Alarms
When an obstruction or movement has been detected and confirmed, the following alarm icons will be
displayed.
Alarms as shown in Test and Operation Mode after PIR and MW Pre-Alarm
Creep alarm as shown in Test and Operation
Mode
4.4 Tamper Indications
Tamper messages are triggered by when the captive screw at the bottom of the unit is opened or the wall
tamper
screws have
been disengaged.
Appears when the tamper screw at the bottom of the unit is properly closed. It
signifies the unit has entered operation.
Appears when the tamper screw at the bottom of the unit is open and that
the
menus are not accessible. This message will also appear at the end of the
power
up
sequence.
Appears when the Wall Tamper screw has been open. This message will also appear
after the power up sequence is finished, should the Wall Tamper
scr
ew
be open
during power up. The detector will enter menu mode after the power
up
sequence
is over.
To Next Page
Loading...
Need help?
General
