Paradox NVX80

NVX80 Installation Manual 27
Section 002:
Display parameters 00x to Display Brightness
Acceptable values 000-005 for brightness level. Actual values 1-5. 0 will set a default value.
Section 003:
PIR parameters 1 + Anti-Mask parameters 1
008 for Relay 1
010 for Relay 2
012 for Relay 3
Alarm 1
* Trigger off
1 Trigger on
Tamper 2
* Trigger off
2 Trigger on
Anti-Mask 3
* Trigger off
3 Trigger on
Microwave Anti-mask 4
* Trigger off
4 Trigger on
PIR 5
* Trigger off
5 Trigger on
MW 6
* Trigger off
6 Trigger on
Clean 7
* Trigger off
7 Trigger on
Trouble 8
* Trigger off
8 Trigger on
009 for Relay 1
011 for Relay 2
013 for Rely 3
Creep Zone 1
* Trigger off
1 Trigger on
Not used
014 I/O
Configuration
Display On/Off 1
* Display Off
1 Display On

Wall Tamper 2
* Wall Tamper Off
2 Wall Tamper On

Relay 2 Polarity 3
* N.O (normally open)
3 N.C (normally closed)

Relay 3 Polarity 4
* N.O (normally open)
4 N.C (normally closed)

Language 5, 6, 7
*** English

5** Portuguese
*6* Not Used
56* Not Used
**7 Not Used
5*7 Not Used
*67 Not Used
567 Not Used
a. A triangle denotes the default setting.
b. If you change the menu color you will need to push one of the OLED buttons to activate the new color.
c. a Value of 000 will set the default value.
Table 2: NVX80 Settings
Programming
Section
Feature Bits Setting
Default
a